Stendker Discus Food 100g Blister

Stendker Diskusfutter (500g Flat Pack) Das neue Stendker GoodHeart Blisterfutter wird durch Gelantine gebunden und flockt daher im Wasser nicht mehr aus. Das Futter belastet das Wasser daher nicht so stark. Zum einfachen Portionieren ist das Diskushauptfutter auf Rinderherzbasis in 100 Gramm Blisterverpackung ideal. Zitat Stendker: "In unserer Diskuszucht seit 40 Jahren erfolgreich und ausschliesslich im Einsatz. Unser Garant für passende und erfolgreiche Ernährung". Zusammensetzung: - Basis Rinderherz: Das eiweißreiche Rinderherz ist gut für das Wachstum - Paprikapulver/Gemüseanteile: gut für Verdauung und Rotfärbung - Vitamine und Spurenelemente: runden die Werthaltigkeit des Futters ab - Gelantine, damit das Futter nicht ausflockt und das Wasser nicht stark belastet wird Dosierung: 3x täglich so viel dosieren, wie die Fische in 10 Minuten fressen.

SuperFish Digi Test pHDigital ph meter for aquariums and pond water. This digital meter measures ph with an accuracy of up to 0.02 units, has an automatic calibration function and makes measuring ph much easier.Accurate pH meter for aquariums and. pond water.Measures pH from 0 to 14 with an accuracy of up to 0.02 units.The device features an automatic calibration function for 1-point (6.86) and 2-point calibration (4.00 - 9.18).Calibration powder is included.Automatic power off after 5 minutes.UseRemove the protective cap before use.Press the power button. Submerge the pH meter up to the Immersion line into the water. The meter is NOT waterproof, never immerse the Never immerse the meter beyond the immersion line. beyond the immersion line into the water.Wait about 30 seconds until the reading is numerically constant.Read the pH of the water.Rinse the electrode with distilled water. rinse, dry with a cloth and put the protective cap.Avoid heat and direct sunlight. 1-point calibration 6.68 The calibration accuracy is ± 0.1 pHDissolve the pH 6.86 buffer powder in a beaker with 250 ml of distilled 25°C warm water.Dip the pH measuring instrument into the water with the pH 6.86 solution and wait about 30 seconds.Press and hold the CAL button for 5 seconds.The display will begin to flash 6.86. When it stops flashing, the pH meter has been calibrated.Rinse the electrode with distilled water. rinse with distilled water, dry with a cloth and put the Put on the protective cap. 2-point calibration 4.00 and 9.18 The calibration accuracy is ± 0.02 pHDissolve the pH 4.00 buffer powder in a beaker with 250 ml of distilled 25°C warm water. Dissolve the buffer powder pH 9.18 in another beaker.Dip the pH meter into the water with the pH 4.00 solution and wait about 30 seconds.Press and hold the CAL button for 5 seconds.The display will begin to flash 6.86.Press the CAL button briefly immediately.The display will flash 4.00. Wait until the flashing stops.Rinse the electrode with distilled water. water.Now immerse the pH meter in the Water with the pH 9.18 solution and wait about 30 seconds.Press and hold the CAL button for 5 seconds.On the display begins to flash 6.86.Press the CAL button immediately briefly.On the display flashes 4.00. Press the CAL button again immediately.On the display now flashes 9.18. If it stops stops flashing, the pH meter is calibrated.The electrode with distilled water Rinse with distilled water, dry with a cloth and put the protective cap on.Care: Keep the electrode clean and dry. Always close the meter with the protective cap. Warranty 1 year manufacturer's warranty. Damage due to improper use (battery leakage, water damage) is not covered. Lift the proof of purchase for proof of warranty. for proof of warranty. The warranty will be voided without proof of purchase! The batteries supplied free of charge have a life of one year. If they are empty at the time of the empty, you must replace them yourself. replace them yourself.